Officials: Fire/Explosion Reported at US Nuclear Plant — Emergency Alert Declared — Fire/Explosion occurred after “unexpected power decrease” in reactor — “Emergency response facilities staffed” — “Abnormal event with potential to impact plant equipment or public health and safety” (VIDEO)

Published: February 9th, 2016 at 11:03 am ET
By
Email Article Email Article
162 comments


U.S. Nuclear Regulatory Commission, Feb 8, 2016 (emphasis added): Facility: BRUNSWICK [Nuclear Plant in N.C.]… Emergency Class: ALERTEMERGENCY DECLARED… RPS [Reactor Protection System] ACTUATION – CRITICAL… MANUAL SCRAM AND ALERT DECLARATION DUE TO ELECTRICAL FAULT RESULTING IN FIRE/EXPLOSION… Unit 1 declared an Alert… due to an explosion/fire in the Balance of Plant 4 kV switchgear bus area. Prior to the Alert declaration, the operators initiated a manual SCRAM due to an unexpected power decrease from 88% to 40%. The licensee has visually verified that there is no ongoing fire and is investigating the initial cause of the event… [T]he licensee reported the following… “a manual reactor scram was initiated due to loss of both recirculation system variable speed drives as a result of an electrical fault. At this time, a Startup Auxiliary Transformer (SAT) experienced a lockout fault; interrupting offsite power to emergency buses 1 and 2. Emergency Diesel Generators (EDGs) 1, 2, 3, and 4 automatically started”… The licensee has notified… DHS, FEMA, USDA, HHS, DOE, DHS NICC, EPA… FDA… and Nuclear SSA…

WWAY, Feb 7, 2016: Electrical damage sets off alert at Brunswick Nuclear Plant… An Alert is the second in increasing significance of four nuclear emergency classifications.

WECT, Feb 8, 2016: [Unit 1] remains in shutdown mode, while officials work through “detailed process/procedures to fully understand this event and make the needed repairs”… An alert… is used when abnormal events have the potential to impact plant equipment or public health and safety… No estimated timeline has been given for getting Unit 1 back into service.

North Carolina Department of Public Safety, Feb 7, 2016: Duke Energy notified the emergency management agencies… of damaged electrical equipment at the Brunswick Nuclear Plant…

Duke Energy, Feb 7, 2016: Alert declared and exited at Brunswick… federal, state and local officials were notified, and Brunswick plant emergency response facilities were staffed…

Watch WWAY’s broadcast here

Published: February 9th, 2016 at 11:03 am ET
By
Email Article Email Article
162 comments

Related Posts

  1. Emergency declared at U.S. nuclear plant after gas leak — “Event poses no threat to public safety” February 26, 2013
  2. Explosion at U.S. nuclear plant triggered emergency alert — It was “of sufficient force to damage permanent structures or equipment within the Protected Area” (VIDEO) #ShearonHarris August 8, 2013
  3. Fire breaks out at U.S. nuclear plant, reactor shut down — Emergency alert lasts over 5 hours due to ‘equipment malfunction’ — Residents discuss fears after many recent problems (VIDEO) January 18, 2014
  4. ALERT: Emergency at US nuclear plant after “massive” fire and multiple explosions — “All of a sudden we heard this loud boom and the whole ground started shaking” — “Intense Flames… Heavy Black Smoke… Chaos” — 100s of fire personnel called in — “We ask that the public stay away from the area” (VIDEOS) March 8, 2016
  5. CBS: Level 2 emergency declared at California nuke plant after ammonia leak — “Orange County Emergency Ops. Center has been activated” — Potential substandard degradation in level of safety of plant November 1, 2011

162 comments to Officials: Fire/Explosion Reported at US Nuclear Plant — Emergency Alert Declared — Fire/Explosion occurred after “unexpected power decrease” in reactor — “Emergency response facilities staffed” — “Abnormal event with potential to impact plant equipment or public health and safety” (VIDEO)

You must be logged in to post a comment.